Victron Centaur 12/100(3) 120-240V Sine Wave Battery Charger

Description

Quality without compromise
Aluminum epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an
adverse environment: heat, humidity, and salt air.
Circuit boards are protected with an acrylic coating for maximum corrosion resistance.
Temperature sensors ensure that power components will always operate within specified limits if needed by
automatic reduction of output current under extreme environmental conditions.

Universal 90-265V AC input voltage range and also suitable for DC supply (AC-DC and DC-DC operation)
All models will operate without any adjustment needed over a 90 to 265 Volt input voltage range, whether
50 Hz or 60 Hz.
The chargers also accept a 90-400 V DC supply.

Three outputs that each can supply the full output current
Three isolated outputs to simultaneously charge 3 battery banks
Each output is capable to supply the full rated current.

Three-stage charging, with temperature compensation
The Centaur charges at a bulk rate until the output has reduced to 70% of the rated Amps, at which a 4-hour timer
begins. After the timed period the charger switches to float rate.
An internal temperature sensor is used to compensate for the charge voltage with – 2 mV/ºC (– 1 mV/ºF) per cell.
A DIP switch is available to select the optimum charge/float voltages for Flooded Lead-acid, Gel or AGM
batteries.

Learn more about batteries and battery charging
To learn more about batteries and charging batteries (including the pro’s and cons of multi-bank charging and
intelligent charging), please refer to our book ‘Electricity on Board’ (available free of charge from Victron Energy
and downloadable from www.victronenergy.com).

Please note: There is no additional cables included with this product.

Additional information

Downloads